Back to Overview | Product Presentation | Help by email

1. What garanty are my product covered by?
2. Am i allowed to repair my product myself?
3. Where can i see what firmware version my AP120 is using?
4. What firmware version should i choose?
5. My rudder is doing a lot of unnecessary correction on my new AP120, is it defective?

There are always 2 years garanty on all our products. Please contact our sales or administration office for further details.

Back to index

By default are you allowed to repair our products because none of those contains high-voltage parts. Please consider that our stated garanty does not cover products repaired by other than our technical department unless a specific appointment has been made.

Back to index

Click on MENU and choose Diagnostic. The firmware version number is located at the bottom of the Diagnostic page.

Back to index

If your AP120 uses an earlier version than 1.0.454, then you choose "AP120 Upd. 1.0.x - 1.0.482".

If your AP120 uses version 1.0.454, then you need to choose "AP120 Upd. 1.0.454 - 1.0.482".


Please note:If you're upgrading from an earlier version than 1.0.454, then your autopilot will restart twice during the upgrade process. This is normal behaviour.

Back to index

AP120 contains self-learning algorithms that calculate your rudders work-speed. It is normal that the rudder will give abnormal corrections in the beginning until the autopilot has calibrated your rudder. Using the autopilot will make the miscorrections go away after a while and provide optimal rudder control.

Back to index